HOME > News

Magazine printing production starting from the design of the layout, they have to master a lot of focus in order to avoid unnecessary mistakes, bouncy ball manufacturers In addition to the magazine printed matter, pictures, book printing also need to pay attention to the following question.

Magazine printing layout must be a placeholder for cutting the neat appearance of the edge of the magazine, if forget to stay when in the design, cutting the space in the process of cutting edge, easy to text cut out, causing the defect, which destroyed the print and value. The other hand, the binding of the magazine, the middle of the spinal space have different requirements. bouncing  ball manufacturers analysis of saddle stitching method, outside the page and inside pages of the ridge curvature of the arc when the folding will lead to the length difference; the inside curvature of smaller folding the outer page because the folding greater need to thicker ridges bit. Ridge width difference is ignored, each page are the same size of the typesetting and printing, binding after the formation of floating mouth; more pages difference more obvious. Cut flush the mouth, may be within the page text part of the cut, destroy the finished product.

Pre-press work, including typesetting, make-up and pagination work. Common prepress problems, including pagination errors lead to folding jump page; folding samples, using the wrong make-up error in the pagination,ignore the paper pattern print a performance, such as writing pressure ridge effect; paper deformation caused by the underside of graphic registration poor processing difficulties or not combined with the appropriate the incision bit and origami bit. bouncy ball manufacturers knows The printing process is often the overprint unstable, overprint quasi inconsistency between the sheets, leaving the processing sequence are difficult to correct location.